are the printed circut boards inside the monitor panels available?? When I took our Clipper out of storage last month, It went to our local RV shop to be prepped for the season, the technician said that the house battery need to be replaced. A trip to Mr Schwab, and a Hundred dollar bill solved that!!.......noooo.. the light on the panel was on! and ended up drainin the battery. so back to same shop.. same tech.. says bad diode in printed circut board! other than this small( I HOPE) problem.. we are looking forward to loading her up and heading out!! : :D :D Have a safe season! everyone and keep em' rollin! see ya on the road :) Danny and Pam in Washington
SOME TIME BACK WHEN MY CONVERTER WAS NOT CHARGING I FOUND CICUIT BOARD AT (PROGRESSIVE DYNAMICS .COM) THEY MAY HAVE WHAT YOU ARE LOOKING FOR. YOU WILL NEED THE MODEL # AND SERIAL #. THEY ARE MORE THAN GLAD TO HELP. CALLING BY PHONE MAY BE BETTER AS OUR CLIPPER PARTS ARE NOW OUTDATED. YET THEY HAD REPACEMENT PARTS FOR MINE.
Monitor panel :wink: It just may be that your only problem is, or was ,that you were low on battery water. This condition will yield two immediate results. You will have low or no twelve volt coach power, and the red light on the panel will be on,(assuming the bulb is good). 8) In a situation like this many a shop might well stick you for a new battery and some rinky dink system testing charge. :shock: Howevever it would be completely out of character for a Les Schwab unit to do this. :D You migt want to look into this just in case you were ripped off,ententionally or otherwise. In passing you will find the low water light can remain on even though the cells are full.The wire probe from the panel has to be in one of the center two battery cells. (If which one matters???)
I DON'T KNOW ELECTRICALLY WHY!! Good Clippering Bob Chaney