Hi Clipper Owners,
Just Wanted To Share This. ;)
Have Read A lot Of Posts, That Are Roof Related, Ie; Leaks, Hatch Problems Etc.
A Roof Vent Cover Does Protect Your Vent Covers.
There Are Many On The Market. Maxx-Air & Camco. I Have Found That They Are Available @
Wal-Mart. You May Need 2ea. They Are About $18.00 Now. You Can Order Online Or Check @ Store In RV Parts.
This Is A Simple Add On To Put Above Your 14" Roof Hatches.
Note: *** Do Not Install Any Covers Over Your Bed Vent Escape Hatch. ***
But Note: If You Have Any Cracked Vent Hatch Covers Or Crack In Sealant Caulking,Or Any Leaking Make Sure You Take Care Of That First. :) You May Want To Clean Old Caulking & Remove Cover Screws & Add New Butyl Seal Tape & Add New Stainless Steel Mounting Screws, Then Add Self Leveling White Dicor Sealant.
These Covers Come With All S.S. Mounting Hardware, Make Sure You Set In Place & Raise & Lower Hatch To Get The Right Amount Of Clearance Then Mark, Then Mount. This Is A Pretty Ease Task. You Will Need A Few Tools & Battery Drill/Driver.
NOTE: Always Use Caution While On Roof. You Can Also Add Small Plywood To Support Yourself.
If You Have Any Question Feel Free To PM Me. >> Clipper Joe
Thanks,
Joe
I got them on Amazon. At the time, they were a couple dollars cheaper than at Walmart, but I suspect that varies, so check both before buying.
I had a minor leak in my bathroom vent. The vent lid wasn't closing correctly (slightly out of alignment) and rain would drip down. The vent hood has eliminated that problem. I just placed them over my current vents, but found that my vents are brittle and cracking. Once I have dealt with mechanical issues, I'm planning on taking my clipper in and having new vents installed over the bathroom and kitchen and the vent hoods re-positioned over them. I haven't closed my vents since they were installed.