Nutn Much

[John Eversoll]

Hey DB 2  I see you...   

Hows the Clipper doing....  Did the radiator repair hold?

Do you want me to send a bottle of the "Bars leak"

take care ,  John

[prophetdaniel2]

     Aw Shucks! so much for the hide in plain sight routine.   
Actually I have not finished the radiator repair.  The snow flew already and the the clipper is..well...buried. Figuratively mind you. A few minutes with a snow shovel  would clear things out acceptably, but I have got a Sheetrock project going on at the moment that threatens to consume my  entire R-n-R. One of the five sisters ( wife's side) is moving in from Juneau, and will need one of the unfinished downstairs bedrooms, go figure Room prep has been an all week long affair, as it was previously used as wall to wall storage.
     I did, however, decide to silver solder the radiator me-self! I finally spoke with someone versed in Radiator repair, who informed me that a shop would likely  snip the veins affected by my level of damage and the silver solder to seal the leak. I then cross consulted with a plumber to learn basic silver-soldering technique. I think I am on the right track now, No Offense about the Bars leak I would just feel better leaving Bars leak as a backup plan in case my soldering sucks.
     Alas, clipper hibernation season is upon me. ...................But I lurk on.........
-D

[John Eversoll]

jUST READING THE NOTE YOU SENT MAKES MY BACK HURT!!!!

Sounds as if you are keeping busey....I beleive that the repair to your radiator will be good

and sounds as if you are doing it the right way!!    Like my late father used to say to me  " what ever you do "do it slow"
and it will be right...  My wife likes the first part!!!!

Hey, keep warm and take care..  Keep in  touch!!      John